LED GU10 Manufacturer in China LED flood lights,LED flood lighting,LED floodlight Manufacturer in China

LED flood lights Single Color adopts 1W high power LED as its luminous body, which is of high brightness, stable performance, long longevity and low power consumption. The input voltage is 110VAC or 220VAC.LED lights current is stable ensured by high efficient and wide voltage constant current driver.
With aluminum housing and 5mm high transparent toughened glass surface, LED floodlight can achieve protection class IP65. Special aluminum heatsink contacts the PCB board so closely that it shortens the path of heat-sinking to ensure longer life of the product. Ventilation condition is needed for the application, or heat-sinking device should be used. This product can be installed very conveniently by using matched aluminum mounting base and the light direction can be adjusted at will. It can be widely used for partial LED lighting, indirect lighting and spot, etc.

Additionally, as a LED light manufacturer and supplier in China, A-ONE LED produced LED flood lighting are equipped with industrial waterproof-grade components and connection. 

 

1.Round LED flood lights 18W


2.Round LED flood lights 36W


3.Square LED flood lights 18W


4.Square LED flood lights 36W

Connect the input connector of the first fixture to the output connector of the DMX console; connec the output connector of first LED floodlight fixture to the input connector of the second flood lighting fixture; etc., as shown in following diagram.

1) Put the output connector of the first LED lightsfixture into a Φ20 thermal shrinking sleeve with glue inside The end of the sleeve should be 40mm from the joint of the cable and the connector.

2) Put the input connector of the second fixture into the Φ20 thermal shrinking sleeve so as to connect it with the output connector of the first LED flood lights fixture.

3) Blow and shrink the sleeve ends with a hair drier so that the sleeve and the signal cable are tightly contacted for waterproof purpose.

The signal output connector of the last LED flood lighting fixture (maximum 30 fixtures) of each series must be sealed with a Φ20 thermal shrinking sleeve and blow and shrink it with a hair drier for waterproof purpose.